install Win32diskimager if you have not already done so.ģ. might as well get the get hyperkins SD erase while your at it, makes getting those pesky extra partitions off your SD card and formatting after installing easierġ.unzip/unpack Retronlabo.7z file to desired locationĢ. a copy of manclouds system restore image that includes what you need on your SD card you keep your roms on after installation.Ĥ. Win32DiskImager for writing the install to your SD cardģ. SD card (regular one, once installed you can use an micro with an adapter but this install does not like micro SD adapters, i used a 4 GB one but you might get by with 2GB) i am in no way responsible for bricked retron 5's, and if your power goes out while flashing the CFW that is possible, just as it would be possible with the official firmware on any device if it powers down when updating like this. The install itself if very easy, using the CFW has a small learning curve but it is easy too once you understand it.Īs always with guides like this, you do this at your own risk. So, first of all if you ever did a factory reset on the retron this should all look familiar as it is the same steps basically. I would like to make a shout out to Mancloud and reminon2 on here as well, without their efforts this wouldn't have seen a public release. So I figured I write a decent tut out for this since this CFW was dumped from my old firmware, i got a lot of user experience with it at the least.
0 Comments
Leave a Reply. |